IN Brief:
- HAROLD 7.4 added nitride laser modelling in October, with further technical details circulated on 16 November.
- HAROLD calculates quantum-well energy levels and gain; PICWave provides dynamic three-dimensional circuit simulations.
- Photon Design reports agreement with experimental LI and IV curves but has not supplied a general accuracy benchmark.
Photon Design has outlined how its HAROLD and PICWave software can be combined to simulate nitride semiconductor lasers, carrying calculations of the active device into dynamic three-dimensional circuit models. The Oxford company’s HAROLD 7.4 release appeared on 23 October; a separate technical communication on 16 November described the nitride modelling workflow in more detail. The work concerns simulation software, not the introduction of a physical laser component.
Nitride emitters are typically formed from epitaxial layers containing gallium nitride, indium gallium nitride and aluminium gallium nitride. By adjusting layer composition, thickness and the arrangement of quantum wells, designers can influence the confined energy states and the optical gain available to the laser. Photon Design’s modelling work addresses the interaction between that semiconductor structure and the electrical and optical response of the finished component.
Nitride semiconductors exhibit piezoelectric and spontaneous polarisation effects that can alter the electric field within the quantum wells. Strain-induced fields change the shape of the band structure and the relative positions of electron and hole wavefunctions, influencing their overlap and the predicted optical gain. HAROLD models the resulting energy levels and gain spectra instead of treating the active layers as though these internal fields were absent. These calculations depend on the material parameters and epitaxial structure supplied to the model.
The gain characteristics calculated in HAROLD can then be exported to PICWave for time-domain simulation of the complete laser arrangement or photonic circuit. HAROLD resolves semiconductor behaviour within the active device, while PICWave examines optical feedback, modulation and interactions with other circuit elements over time. That division of work avoids representing a detailed epitaxial calculation as though it were itself a complete three-dimensional model of every optical component in the circuit.
Directly modulated lasers receive changing electrical inputs, and their optical output cannot be described adequately by a single steady-state operating point. A design that produces the required gain under static conditions must also behave acceptably when driven with changing current. Time-domain calculations provide a way to examine the response of a device and its interaction with surrounding circuit elements without assuming that a satisfactory static model alone establishes dynamic performance.
Photon Design identifies Fabry–Pérot and distributed-feedback lasers among the structures supported by the combined approach. Those geometries have different optical feedback arrangements: the former relies on a resonant cavity, while the latter uses a grating to select the optical mode. The company also describes broader, tuneable circuit-level simulations as part of the PICWave design flow. Such calculations depend on the material data and device assumptions supplied to the model; the announcement does not establish a universal accuracy figure for every laser structure.
Photon Design has compared simulated and experimental light–current and current–voltage characteristics, reporting close agreement for the examples shown. Light–current curves indicate how optical output changes with drive current; current–voltage curves describe the electrical response of the device. Agreement in both provides more useful evidence than comparing optical output alone, but the available examples do not establish an error margin or performance guarantee covering different epitaxial designs, operating temperatures and laser architectures.
The cited applications include blue and near-blue laser emission at approximately 400–500 nm, as well as optical sources for industrial manufacturing, research equipment, medical systems, storage and defence. The modelling methods can also be applied to Fabry–Pérot and distributed-feedback laser structures. Different cavity arrangements and modulation requirements place different demands on the material gain model, making measured device characteristics an important part of subsequent design validation.
Photon Design says the software can run on a standard workstation or laptop without cloud computing. No published benchmark establishes the runtime of a representative large nitride circuit, and the November technical account does not quantify a new reduction in simulation time. The confirmed development is the nitride device modelling capability within the October HAROLD update, followed by the more detailed November description of how its results are transferred to PICWave.



